To do this, turn on the ignition, use your centralized button to enter the digits, several quick presses (example: 2 for digit 2) then a stop of one and a half seconds to validate the digit and resume, duplicate the procedure until you have entered the entire code. This should allow your Ford Ka to start without having to remove the immobiliser. To do this, turn on the ignition, use your centralized button to enter the digits, several quick presses (example: 2 for digit 2) then a stop of one and a half seconds to confirm the digit and resume, duplicate the procedure until you have entered the entire code. This should let you start your Mazda CX 7 without having to remove the immobiliser. An immobiliser is an anti-theft device that will only allow your car to start if it receives the correct code from the car key. This prevents thieves from being able to bypass your car’s ignition system and driving off with the vehicle. Most modern immobilisers have a transponder embedded in the car’s key fob that transmits a code to the To do this, turn on the ignition, use your centralized button to enter the digits, several quick presses (example: 2 for digit 2) then a stop of one and a half seconds to validate the digit and resume, repeat the operation until you have entered the full code. This should allow your Nissan Cabstar to start without having to remove the immobiliser. Location. Gloucestercotshirewolds. Jan 20, 2015. #3. Basics first, check the earth by putting a jump lead between battery negative and engine block, check you have 12v to the spade connection on the solenoid on ignition position 3. P. Part Number: AMR4956. All Discovery 300Tdi models. FREE CARRIAGE APPLIES TO MAINLAND UK ONLY. Pictures are for reference only and specifications may alter without notice. Product specifications are given but it is up to the end user to ensure that the product is fit for that purpose. Up to 2000 there is a chip in the plip that turns off immobilizer when it is close to ignition barrel ( red light on instrument cluster go's out). If you have to press the unlock button on plip to start the engine, the chip in plip is usually buggered. Could be the transponder coil that is around the ignition barrel ,but usually plip. Posted December 14, 2016. Just to update this, i popped round to see him last night and had a quick look at it, i thought it was worth a check of the fuses. Number 1 in the lower satellite fuse box had blown which the manual states is for the "anti theft system". Replaced this and it's all working fine. hGbXk.